
116
2535J–AVR–08/10
ATtiny13
Notes: 1. Typical values at +25
°C.
2. “Max” means the highest value where the pin is guaranteed to be read as low.
3. Not tested in production.
4. “Min” means the lowest value where the pin is guaranteed to be read as high.
5. Although each I/O port can under non-transient, steady state conditions sink more than the test conditions, the sum of all IOL
(for all ports) should not exceed 60 mA. If IOL exceeds the test condition, VOL may exceed the related specification. Pins are
not guaranteed to sink current greater than the listed test condition.
6. Although each I/O port can under non-transient, steady state conditions source more than the test conditions, the sum of all
IOH (for all ports) should not exceed 60 mA. If IOH exceeds the test condition, VOH may exceed the related specification. Pins
are not guaranteed to source current greater than the listed test condition.
ILIH
Input Leakage
Current I/O Pin
VCC = 5.5V, pin high
-1
1
A
RPU
Pull-Up Resistor, I/O Pin
VCC = 5.5V, input low
20
50
k
Ω
Pull-Up Resistor, Reset Pin
VCC = 5.5V, input low
30
80
k
Ω
ICC
Supply Current,
Active Mode
f = 1MHz, VCC = 2V
0.3
0.35
mA
f = 4MHz, VCC = 3V
1.6
1.8
mA
f = 8MHz, VCC = 5V
5
6
mA
Supply Current,
Idle Mode
f = 1MHz, VCC = 2V
0.08
0.2
mA
f = 4MHz, VCC = 3V
0.41
1
mA
f = 8MHz, VCC = 5V
1.6
3
mA
Supply Current,
Power-Down Mode
WDT enabled, VCC = 3V
5
10
A
WDT disabled, VCC = 3V
0.5
2
A
Table 18-1.
DC Characteristics, TA = -40°C to +85°C (Continued)
Symbol
Parameter
Condition
Min.
Typ.(1)
Max.
Units